- Highest heat resistance of common desktop filaments (~115°C)
- Exceptional impact strength — extremely difficult to shatter
- Optically clear in natural form
- Chemical resistance to many solvents
- Bonds with IPS cement for post-processing
- Requires 300°C+ hotend and all-metal hotend
- Enclosed chamber with active heating essential
- Extreme moisture sensitivity
- Significant warping without proper setup
- Not beginner-friendly under any conditions
Polycarbonate is the end of the road for heat resistance on a desktop printer. Nothing you can print on a standard CoreXY will survive higher sustained temperatures: 115°C before deflection, 130°C on some grades. If you’re printing parts that live inside an enclosure, near electronics, or in any environment that would destroy PETG or ASA, PC is the answer.
The processing requirements are real. You need a hotend that can sustain 300–320°C without degrading — all-metal only, no PTFE lining. You need a chamber that actively heats to 65–70°C before the print starts, or you’ll get delamination on tall parts. Bed adhesion requires either Garolite sheet or PEI with a thin layer of glue stick. Skip any of these and you’ll spend a day watching parts warp and peel.
Moisture is the silent killer. PC absorbs water faster than nylon and produces far worse results: bubbling, rough surfaces, catastrophic layer failure. Dry every spool at 80°C for 8–12 hours before a print. Print from an active dryer. Never leave an open spool overnight in a humid environment. Do those things and PC is a reliable, repeatable material on the right machine.
Most printable PC on the market. Lower warp than standard PC. First choice for builders new to polycarbonate.
PC/ABS blend — easier than pure PC, retains most heat resistance. Best for Prusa users.
Better chemical resistance than standard PC. Harder to print but worth it for demanding environments.
| Printer | Rating | Notes |
|---|---|---|
| Voron 2.4 | EXCELLENT | Ideal platform. 300°C+ capable hotend required (Rapido UHF, Dragon HF). Chamber heater essential. |
| Bambu X1C | GOOD | Hardened nozzle + high-temp hotend variant. Chamber heats to ~45°C — marginal for pure PC. PC blends work better. |
| Voron Trident | EXCELLENT | Same as 2.4. Chamber heater required. |
| Prusa MK4 | POOR | Open frame, no chamber. PC-ABS blends possible with enclosure mod. Pure PC not suitable. |
| Bambu A1 / A1 Mini | NOT RECOMMENDED | No enclosure. Not suitable for PC. |