- Better heat resistance than PLA — functional up to ~80°C vs ~60°C
- Excellent layer adhesion — nearly isotropic strength
- Chemical resistance — handles mild acids, fuels, water
- Flexible enough to avoid brittleness at thin walls
- Food-safe when printed correctly (though layer gaps prevent sterilization)
- Strings more than PLA — requires tuning
- Absorbs moisture faster than PLA — store sealed
- Bonds permanently to smooth PEI — use textured sheet only
- Enclosed chambers can cause warping if ambient runs hot
- Scratch resistance is poor compared to ABS or ASA
PETG is the filament you reach for when PLA isn’t tough enough but you don’t want to deal with ABS. Better heat resistance, better impact strength, prints on the same machines with minimal changes. The catch: it strings, it sticks too aggressively to smooth surfaces, and it drinks moisture faster than PLA.
Get a textured PEI sheet if you don’t have one. Keep retraction short; PETG doesn’t like long pulls. And dry it before any print that matters. Do those three things and PETG is nearly as easy as PLA.
Use it for: tool holders, cable clips, brackets, anything in a car or garage, functional enclosures, parts that need to survive dishwashers.
Don’t use it for: outdoor UV exposure (use ASA), high-temp applications above 80°C (use ABS or PA), or anything that needs to be very rigid and thin (use ASA or ABS).
Tuned for Bambu printers but runs well on anything. High-flow variant pushes past 200mm/s on a capable hotend. Consistent diameter.
Best-in-class consistency. Runs exactly at published settings. More colors than most. Worth the price on anything that matters.
Reliable workhorse. Slightly more stringing than premium options. Fine for functional parts where appearance doesn't matter.
Widely available, consistent, no surprises. Good default if you can't get Prusament. Diameter tolerance is adequate.
Works but strings aggressively. Dry it before use without exception. Fine for throw-away prototypes.
| Printer | Rating | Notes |
|---|---|---|
| Bambu X1C / P1S | EXCELLENT | AMS compatible. Use Generic PETG profile. |
| Bambu A1 / A1 Mini | EXCELLENT | AMS Lite compatible. Runs without enclosure fine. |
| Voron 2.4 | EXCELLENT | Enclosed chamber — vent it or keep temps below 40°C ambient. PETG hates too much heat. |
| Voron Trident | EXCELLENT | Same as 2.4. Open door or crack enclosure slightly. |
| RatRig V-Core 3 | EXCELLENT | Enclosed — same enclosure warning applies. |
| Prusa MK4 | EXCELLENT | Has a dedicated PETG profile. Textured sheet recommended over smooth for release. |
| Bambu A1 Mini | GOOD | No enclosure helps with PETG. Good adhesion on textured PEI. |