Enclosure for Voron 2.4 & Trident
A proper enclosure is what separates a Voron from any open-frame printer. Panel material, sealing quality, and filtration determine whether you can reliably print ABS and engineering materials. These are not afterthoughts — plan them from the start.
Enclosure components
5 productsPolycarbonate is the best panel material for high-temp printing — it holds up to 110°C+ chamber temps without deforming and provides better heat retention than ACM or acrylic. Order custom-cut from TAP Plastics (US West), ePlastics, or a local plastic supplier. Measure your frame panels carefully before ordering.
Buy at TAP Plastics →Aluminium Composite Material panels are lighter than polycarb and easier to cut locally. Heat retention is slightly worse than polycarbonate for high-temp chambers. Popular with builders who want a more industrial aesthetic or have access to local metal fabricators.
Buy at Local fabricator →The standard sealing solution for Voron panel gaps. 3M VHB foam compresses around the panel edges and creates a decent thermal seal. A properly sealed enclosure can reach and hold 60°C+ chamber temps, which is the target for printing ABS without warping.
Buy at Amazon →The go-to exhaust fan for Voron enclosures. Used for chamber exhaust to push filtered air out of the enclosure, and as the recirculation fan in the Nevermore filtration system. $8 each means you can buy two or three without worrying about it.
Buy at Amazon →The community-standard active carbon filter for Voron enclosures. Print the housing (ABS/ASA), source the BOM (~$20 in parts: carbon pellets, magnets, fan), and run it with a Klipper macro. Filters VOCs from ABS/ASA printing — essential for enclosed spaces. Recirculates heated air rather than exhausting it, helping maintain chamber temp.
Buy at Community BOM →Affiliate links used — Modern Makes may earn a commission on purchases. This doesn't affect our recommendations. See disclosure.
Panel material comparison
Acrylic panels can work but may warp near the bed at high chamber temps. Polycarbonate is strongly recommended for enclosures targeting 60°C+ chambers.