Full Specifications
| Type | Print-it-yourself |
| Part Cooling Fans | CPAP (7040), 5015 |
| Compatible Printers | Voron V0.1, Printers for Ants |
Pros & Cons
Pros
- ✓CPAP blower delivers high CFM and very high static pressure — stronger part cooling than blower fans
- ✓Shutter switches between internal (closed-loop, ABS) and external (PLA/PETG) air intake
- ✓Backup 5015 Mailbox duct swaps in without dismantling the toolhead
- ✓No loss in X or Z travel, at most 3mm in Y
- ✓Wide extruder and hotend support
Cons
- ✗Requires Wonsmart WS7040 fan + driver board + Klipper Expander (or logic-level control) — extra cost and wiring
- ✗Fan can pull 2.8A at full load — needs a suitable MOSFET, not a standard MCU fan header
- ✗CPAP hose routing is tight on the v0.1
- ✗Hotend can struggle to hold temp at high fan output — may need PID tuning or a stronger heater