Dragon Burner Peck
Open Source / Community

Dragon Burner Peck

Contender Experimental flexure probe for the Dragon Burner — the hotend itself is the Z probe. Not yet in beta; may never be released.
USD $0

Full Specifications

Type Nozzle Contact
Klipper Native Yes
Installation Complexity Hard
Open Source Yes

Pros & Cons

Pros
  • Uses the hotend itself as the probe — no separate probe hardware
  • BOM is just 2 grub screws + wire
  • Sets Z offset and builds a bed mesh like FlexTap
  • Works with Dragon ST/HF, Rapido HF, Revo Voron, and Dragon Ace
Cons
  • EXPERIMENTAL — not in beta, may never be released
  • Requires cutting thin walls and calibrating grub screws with a multimeter
  • Probe properties change with chamber temperature — probe cold or fully heat-soaked
  • Can damage flex plates during testing; frequent toolhead rebuilds likely
  • Inaccurate bed mesh on v0 (cantilever bed + trigger force)

Source files

GitHubchirpy2605/voronCommunity project: BOM, print files and build docs.(opens in a new tab)