Generic / AliExpress

Silicone Bed Heater 235x235mm 24V

Contender DC 24V bed heater — no SSR required, but thermal ceiling is lower than AC alternatives
USD $15

Where to buy (1)

Listed at ~$15 USD. Vendors set their own prices.

AliExpress (various) (opens in a new tab)

Full Specifications

Type Bed
Wattage 200W
Voltage 24V
Size 235×235mm

Pros & Cons

Pros
  • Runs at 24V DC — no SSR, no mains wiring, connects directly to mainboard bed output
  • Lower barrier to entry — simpler wiring and no AC safety requirements
  • Acceptable for PLA and PETG beds — reaches 60-70°C reliably at 24V
  • Lower cost and simpler sourcing than an AC heater + SSR combination
Cons
  • ~200W at 24V is the practical limit — reaching 110°C for ABS/ASA is slow and often inconsistent in an open frame
  • 24V bed heaters draw 8-10A continuously — that's a significant portion of most 24V PSU headroom
  • Not recommended for sustained high-temp printing (ABS, ASA, PA, PC) where an AC heater is clearly superior
  • Generic quality control issues apply — pad adhesion and silicone consistency vary by source

Where to Buy