PTC Ceramic Fan Heater
Generic / Community

PTC Ceramic Fan Heater

Contender Community AC chamber heating mod — effective but requires AC mains wiring inside the printer
USD $30

Where to buy (1)

Full Specifications

Type Chamber
Wattage 300W
Voltage AC
Size Varies (builder-specific mounting)
SSR Required true

Pros & Cons

Pros
  • PTC elements are self-limiting — resistance rises sharply above the Curie point, preventing thermal runaway at the element level
  • 300-500W pushes chamber temps to 50-60°C efficiently — better than any 24V chamber solution
  • Low component cost — PTC heating elements are $20-40 from AliExpress; add a 5015 blower fan and SSR
  • Widely documented in VzBot and HevORT communities
Cons
  • AC mains voltage inside the printer enclosure — requires careful wire routing, strain relief, and a proper grounded chassis
  • SSR required for Klipper control — adds cost and wiring complexity
  • Requires a chamber thermistor for closed-loop temperature control in Klipper
  • Not a drop-in mod — requires drilling, mounting, and custom Klipper configuration
  • No printed parts exist universally — mounting solutions are builder-specific

Where to Buy