50W 24V Heater Cartridge
Slice Engineering

50W 24V Heater Cartridge

Contender The Voron community’s high-wattage standard — 50W ensures fast heat-up and thermal recovery at aggressive print speeds
USD $15.99

Where to buy (1)

Listed at ~$16 USD. Vendors set their own prices.

Fabreeko (opens in a new tab)

Full Specifications

Type Heater Cartridge
Wattage 50W
Voltage 24V
Size 6×20mm

Pros & Cons

Pros
  • 50W vs standard 40W — faster heat-up, better thermal recovery under high-speed extrusion
  • Fits standard 6×20mm heater block bore — direct replacement for any hotend that accepts a 6mm cartridge
  • Slice Engineering’s build quality is well-regarded — consistent wattage output and insulation
  • Widely recommended in Voron community — the default high-wattage upgrade recommendation
Cons
  • More expensive than generic cartridges — but the quality differential justifies the cost
  • Must verify hotend block supports 6mm bore — most modern hotends do, but some proprietary blocks differ

Where to Buy